Technical Information
145
G 1xxx/G 2xxx
(mounted on the left toekick) for power. If power is present, then check
the connectors and wiring. If not, then go to the next step.
5. Check for power coming off of the electronic board. If no power, then
replace the electronic board. If power is present, check wiring from
electronic board to electrical connector. Replace and repair as necessary.
See Section 100-4.5 or 100-4.6.
3.16
Fault Code F14:
Water Intake Fault: Heater Pressure Switch
Symptom:
The program is interrupted and the drain pump is operated.
See Table 080-3 for model-specific fault indications.
Background
information:
With the circulation pump operating after a water
intake step, the heater pressure switch is checked to ensure that sufficient
water pressure exists in the wash water circuit. For this the heater relay must
have been activated.
Cause:
During a heating step the heater pressure switch may have registered no or
insufficient water pressure at the circulation pump.
Remedy:
1. Check the dispensing of detergent and rinse aid. Excessive foam
development means that the pressure at the heater pressure switch will
be reduced.
2. Check for correct water level within the machine (water level should be
just under the filter arm). See Section 050-4.35.
3. Check all filters for blockages.
4. Check if the circulation pump is defective by performing the following steps:
a. Open the dishwasher door and insert the yellow bypass tool into
the latching mechanism.
b. Turn on the dishwasher and select and start a wash program.
c. After the 30-second drain step, pay attention to the lower spray
arm. As water enters the cabinet the circulation pump should be
operating, increasing the water flow pressure. You should begin to
see a small stream of water coming out of the lower spray arm.
Warning!
Keep your hands on the door handle as you perform this test. If you see
water begin to flow out of the lower spray arm, press the door handle to
pop the bypass tool out of the door lock and shut off the machine. If this
is not done, there is the danger of water spraying out of the dishwasher.
d. If you see the water flow out of the spray arm, the circulation
pump is operating and there is no blockage. Press the door
handle to pop the bypass tool out of the door lock.
e. If you see no water, continue troubleshooting.
Содержание ADVANTA G 2170
