Program settings
108
Activating the
conductivity sen-
sor
The conductivity is measured during the final rinse phase (see pro-
gram charts).
...
Final rinse 1
or
Final rinse 2
Conductivity Monitoring
Conductivity Monitoring
Yes
No
-
Yes
The conductivity is being measured.
-
No
The conductivity sensor is deactivated.
Select an option using the
and
arrow buttons.
Press
OK
to save the setting.
Changing water
quantity
Increasing the water level is advisable if a large amount of water
clings to items due to the structure of the wash load or if a heavy
build-up of foam might occur due to the type of soiling (e.g. blood)
and the process chemicals used. The additional amount of water re-
quired depends on the type of basket or mobile unit used, the type of
soiling and the load.
If a lightly soiled load is being reprocessed which does not hold much
water, the amount of water can be reset to the factory default amount
to save water and energy.
...
Water volume change
Water volume change
0.0
l
(0.0 - 8.5 l )
The water quantity can be increased in 17 oz. (0.5 l) increments, or
set back to the factory default amount. The possible range is shown
in the bottom line. The setting “0 l” equates to the factory default set-
ting.
Use the arrow buttons
(higher) and
(lower) to alter the water
quantity.
Press
OK
to save the setting.
