Midway 40272, Руководство по эксплуатации игры

Страница: 8 / 93

6 . the pedestal near the cabinet and align the opening in the pedestal the ends of the
Slide the pedestal forward onto the rails leaving enough space to attach the wiring harness. Mate
each cable connector and press firmly to seat the contacts, Ensure no wires are pinched during
pedestal attachment. Fasten in place with the -20 tamper resrstant screws and large flat washers
provided in spare parts. Tighten the screws firmly the wrench provided, and then tighten the bolts
for the mounting rails.
7 . Lower each leg leveler until the pedestal is stable and level the cabinet. Adjust levelers
both are flush and parallel with each other. inspect for pinched wires, and then insert and
tighten the remaining fasteners to attach the two pieces as one.
8. Remove the hasp used to secure the rear door from the spare parts bag. Remove the lock bracket
nuts from above the rear door Slide the hasp bracket onto the bolts until it protrudes through
the hole in the cabinet, and then reinstall nuts.
9. Modify the lock plate by removing the hardware at the top of the rear door, rotating so the slot
above the door and
the nuts and bolts.
Reinstall the rear door onto the cabinet and lock it. If necessary, insert an extra padlock in the hasp at
this install the screws at the top and sides of the rear door and tighten snugly.
11. Remove the power cord from the spare parts bag and insert a of it the cord clamp. Make
sure there is enough slack before plugging the cord into the receptacle.
Line Cord Installation
7