Midstream Modus S 1100, Руководство по установке

Страница: 2 / 11

2
MODUS S INSTALLATION GUIDANCE
Contents

24 mm standard wrench for M16 screws

30 mm standard wrench for M20 screws

#8 Allen key

Powered drill-screwdriver with adjustable torque
(clutch)

Torx T25 insert bit for powered screwdriver (to be
used with M5 screws)

Torx T25 manual screwdriver

Torx T30 insert bit for powered screwdriver (to be
used with M6 screws)

Torx T30 manual screwdriver

Monkey pliers

Electrician scissors for wires

Ph2 screwdriver

Slotted manual screwdriver for connector’s screws
(blade dimensions: 3.5(w) x 0.6(t)mm)

Wire stripping pliers
DO NOT USE PERCUSSION DRILLS!
Equipment list
Prior to starting the installation, check the equipment list
to be sure of using the correct tools (mounting screw(s)
and nut(s) are not supplied).

Wear adequate working gloves, safety shoes and
hard hats to protect yourself from material dropping

Never energize the lamp if wiring operation are
not completed
H&S check
Section PAGE
1 General notes 3
2 Safety instructions 4
3 Contents 5
4 Bracket mounting and aiming 6
5 Visor mounting 7
6 Electrical connections 7
6A Floodlight connection 8
6B Power supply connection 13
6C Control connection 15
6D Cabinet Driver 17
7
Electrical specifications 18
8 Weight and Windage 18
9 Dimensions 19
1. General notes
This user manual contains important information on safe operation of the Luminaire.
Read and follow all safety notes and all instructions. Save this manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National
Electric Code (NEC) standards or International Electro
technical Commission (IEC) standards.
The Luminaire is suitable for wet locations.
This luminaire has to be replaced only by the manufacturer, by its service staff or by qualified personnel.
The luminaire is suitable for outdoor use
IP66:
The product is protected against powerful water jets.
DO

Store the Luminaire with care, avoiding placing the lenses to the ground which may scratch or damage
them

To avoid damaging the Luminaire, keep it in the original packaging when storing

When handling the Luminaire, wear industrial safety gloves and safety boots

Operate on circuitry when the electrical power supply is disconnected
DO NOT

Apply mains voltage through the control system cable. This will damage the luminaire that will no longer be
covered by warranty

Unnecessarily remove the Luminaire from the box

Leave the LED Luminaire switched on when rested on the ground with optics facing down

Place the Luminaire with the lens on the pavement, dirt and metal surfaces

Clean the lenses with any industrial detergent, but with water-soaked cloth if needed
midstreamlighting.com call +44 (0) 207 584 8310
3