Midian PARTI-1, Руководство пользователя

Страница: 2 / 26

2
HARDWARE SPECIFICATIONS
Voltage/Current:
External Power 13-18 VDC
Standby Current 138 mA
Radio Inputs/Outputs:
Audio Input Impedance ~ 2.7k
Audio Input Level 500 mvpp – 5 vpp
AGC Dynamic Range
30 db
Audio Output Level Adjustable from 140 mvpp to 3 Vpp unloaded
Audio Output Impedance 1 K or 47 K Jumper Selectable
PTT Out: Open-Collector – Logic Low
Mechanical:
Dimensions: 1.45" H x 6.1” W x 7.0" L
Operating Temp: -30° to +60° C
INSTALLATION OVERVIEW
1. Test the radio and PA system for functionality.
2. Program the unit per the Product Programming Section of this manual.
3. Connect the unit into the radio and PA system per the Hardware Connection Section of this manual.
4. Program the radio per the Radio Programming Section of this manual.
*** Midian is not responsible for any damage/loss resulting from the use of Midian’s products.
GENERAL INFORMATION
The VAE-80 is a voice alarm encoder capable of playing back 8 different 20 second user pre-recorded messages
over a radio channel. Each of these 8 messages is controlled by 8 individual logic low inputs (relay contacts) from
an alarm panel. The 8 alarm messages can also be activated by DTMF sent from a radio equipped with a Touch
Tone keypad or optionally from a cellular or land line phone. Another optional feature allows the 8 messages to be
simultaneously played back over a PA system or a 600 ohm line.
The VAE-80 is two Midian products, the PARTI-1 and the AE-1 combined to make a single product. The PARTI-1
interface is used to program the functionality of the VAE-80. The AE-1 module inside the VAE-80 will never need
to be programmed.
PRODUCT PROGRAMMING
Midian’s VAE-80 is programmed via Midian’s KL-4F programmer, KL-4F-PC1 programming cable and our free
MPS software. Please reference the KL-4F manual for setup instructions of the programming software
and hardware. From the product selection screen in the software, select the PARTI-1 from the list and click
OK.
Set the parameters of the software to fit the application. If any clarifications on a feature are required, move the
mouse cursor over the feature name until the question mark appears and right click, a definition of the feature will
be shown.