Midea MONB-76C, Техническое руководство

Страница: 75 / 87

Midea R22 T1 side-discharge duct manual MCAC-RTSM-201301-01
64
on the display panel of the indoor unit starts flashing.
※
Use the MODE select button to select AUTO. In the multi system, to avoid mode conflict;
auto-mode is taken as cool mode.
※
Push the TEMP button to set the desired room temperature.
※
The most comfortable temperature settings are between 21
°C
and 28
°C
※
Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel
of the indoor unit lights. The operating mode of AUTO FAN SPEED is automatically set and there
are no indicators shown on the display panel of the remote controller.
※
Push the ON/OFF button again to stop the unit operation.
Notes:
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by
sensing the difference between the actual ambient room temperature and the set temperature on the remote
controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually .
3) COOL, HEAT, and FAN ONLY Operation
※
If the AUTO mode is not comfortable, you may manually change the settings by using COOL,
DRY, HEAT (HEAT PUMP units only), or FAN ONLY modes.
※
Push the TEMP button to set the desired room temperature.
※
When in COOLING mode, the most comfortable settings are 21
°C
or above. When in HEATING
mode, the most comfortable settings are 28
°C
or below.
※
Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
※
Push the ON/OFF button. The operation lamp lights and the air conditioner start to operate per
your settings. Push the ON/OFF button again to stop this unit operation.
Notes:
The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps1
、
3 and 4 may
be performed.
4) DRY Operation
※
Push the MODE button to select DRY.