15
5.6 Changing the light bulb
CAUTION!
•
WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of
electric shock.
•
Wear protective gloves to change the light bulb.
•
To make the replacement, proceed as follows:
•
Disconnect the power supply from the power socket or switch off the circuit breaker of the unit's power
socket.
•
Unscrew the glass lamp cover anticlockwise (note that it might be stiff) and change the light bulb with a
new one of the same type.
•
Screw the glass lamp cover back into place.
•
NOTE:
Use only halogen lamps 25-40 W / 220 V-240 V, T300°C.
5.7 Disassembly of convection motor.
WARNING: Turn off the electrical power supply to the
appliance prior to servicing it. Failure to disconnect the power
supply during service may result in an electrical shock or fire
hazard.
Step 1: Use a screwdriver to remove the screws on the back
of the cavity inside to disassemble the convection motor
cover, and then pull it out from the clipping hole.
Step 2: To reassemble the convection motor cover, perform
the operations described above in reverse
6.
TROUBLESHOOTING
CAUTION!
Refer to the chapters on safety.
11.1 What to do if...
Problem
Cause Possible
Solution
The oven fails to heat.
The oven is off.
Switch on the oven.
The oven fails to heat.
The end of cooking is on position "0"
Position the End of Cooking on manual
The oven fails to heat.
You have not selected the required settings. Check that all the settings are correct.
CLIPPING
SCREW
