Midea MHC-V10W/D2N1, Инструкция по установке и эксплуатации

Страница: 33 / 96

31
(a) Minimum cable section AWG18 (0.75 mm 2 )
(b) The thermistor cable are delivered with the unit
*
：
if the current of the load is large, an AC contactor is needed.
NOTE: Please use H07RN-F for the power wire, all the cable are connect to high voltage except for thermistor cable and cable for user interface.
1 High voltage wire hole
2 Low voltage wire hole
3 Drainage pipe hole
4 Water outlet
5 Water inlet
1
2
3
1 High voltage wire hole
2 Low voltage wire hole
3 High voltage wire hole
4 High voltage wire hole
5 Drainage pipe hole
6 Low voltage wire hole
7 Low voltage wire hole(backup)
8 Low voltage wire hole(backup)
9 Water inlet
10 water outlet
1
2
3
4
5
6
7
8
9
1-phase 5/7/9 kW
1-phase 10~16kW
3-phase 12~16kW
1.Equipment must be grounded.
2.All high-voltage external load, if it is metal or a grounded port, must be grounded.
3.All external load current is needed less than 0.2A, if the single load current is greater than 0.2A, the load must be
controlled through AC contactor.
4.AHS1" "AHS2", "A1" "A2", "R1" "R1" and "DTF1" "DTF2" wiring terminal ports provide only the switch signal.
5.Expansion valve E-Heating tape,Plate heat exchanger E-Heating tape and Flow switch E-Heating tape share a control port.
6.WIRING: transfer board/13 to 40 connection priority
10
5
4