En 14
English
Storage
Perform care and cleaning by following the procedures in “Cleaning and Storage”,
and fully wipe up any moisture inside the hybrid humidifier body, allow it to dry
completely in the shade, and then pack it back in the original product box with the
User’s Manual, and store it in a location with low humidity.
Before Requesting Repairs or Service
WARNING
This product can be disassembled and repaired by qualified repair technicians only.
If you find any problems, follow the troubleshooting procedures below.
Problem
Primary cause
Remedy
The power does
not turn on.
Is the power cord plugged
•
into the outlet?
Plug the power cord into the outlet.
No mist is formed,
or the amount of
mist is small.
Is the Power/Water
•
indicator (P/E) lit red?
The ceramic disc must be
•
replaced.
Fill with water.
•
Even if the Power button is pressed
•
immediately after the Power/Water
indicator (P/E) turns off, the hybrid
humidifier does not produce mist for
about two minutes. This is because
the water temperature is heated to
at least 60°C for sterilization before
starting the misting operation.
Replace the ceramic disc (See page
•
13).
The Power/Water
indicator (P/E) is lit
red even though
water was filled.
Is the water tank loaded
•
in the hybrid humidifier so
that it fits securely?
Load the water tank so that it fits
securely.
A smell is emitted.
Are you using water other
•
than clean water?
Drain the water left in the water tank,
and clean by following the procedure in
"Cleaning and Storage".
The mist nearly
stops once every
minute.
This is not a malfunction.
•
To prevent water from
collecting at the mist
outlet, fan motor stops
operation about once every
minute, and the fan stops
for about two seconds.
This is normal operation, and it is not a
malfunction.
01̲MD-KH1001̲3L̲EnFrGe.indb En14
01̲MD-KH1001̲3L̲EnFrGe.indb En14
2012/06/26 11:53:23
2012/06/26 11:53:23
