Middle Atlantic C3-XX-LDXU, Инструкция

Страница: 12 / 14

Page 12
ATTACHING YOUR DISPLAY TO THE HORIZONTAL EXTRUSION (CONTINUED)
3. Use power driver, Phillips bit, (4x) interface pan head screws (IH-A) through (IH-M), spacers (IH-N),
and washers (IH-P) to attach the interface pair to the back of your display as shown. ( FIGURE M )
IH-P
IH-N
TIP
: Use the magnets on each ring to stow the cords out of view behind your display.
NOTE : Remove your display by pulling down on the cords to open the interfaces, and then bringing the
bottom forward from the horizontal extrusion while lifting up and away from the wall.
4. Carefully team lift your
display and hook the
upper part of both
interfaces (P) over the top
of the horizontal extrusion
(G).
5. Carefully push on the
bottom of your display
until the lower part of both
interfaces click into
place over the bottom of
the horizontal extrusion.
IH-P
Location where spacer (IH-N)
is used, if necessary.
NOTE : Back of display
shown
(display not included)
.
FIGURE M
N
Cords for
opening
interfaces.
P
IH-A through
IH-M
P