Middle Atlantic C3-XX-LDXU, Инструкция

Страница: 10 / 14

Page 10
ATTACHING HORIZONTAL EXTRUSION AND MAKING MICRO ADJUSTMENTS
1. Slide the interlock tabs on the upright pair horizontal mounts (positioned with the set screws on the
bottom) into the two channels on the back of the horizontal extrusion (G) as shown. ( FIGURE H )
NOTE : Verify the torque on your power
driver is on the lightest setting and only
increase as necessary.
2. Use power driver, #2 Phillips bit, extrusion
end caps (H) and (4x) ¼”-20 x ½” end
cap screws (J) to attach an end cap on
each side of the horizontal extrusion.
4. Center the horizontal extrusion with your credenza and then use a #2 Phillips screwdriver to tighten
the screw on the bottom of each horizontal mount to fix it in place.
5. Carefully attach the covers (R) to the front of your uprights.
FOR DUAL DISPLAY CONFIGURATIONS ONLY : If you purchased a C3 Series Display Mount Large
Cover Option (C3-XX-XCVR-BK) for your dual display configuration, refer to the instruction sheet
(100-00035) and use the option instead.
• Each micro display height interval is spaced 1” (25 mm) apart.
3. While carefully lifting the extrusion and placing the horizontal mounts over the upright pair, use the
notch openings on the bottom of the mounts to select your micro display height interval (the same
number for each horizontal mount) and secure each one with a single wire snap pin (K) through the
holes right above. ( FIGURE J )
NOTE
:
• There are 7 micro display height intervals
labeled 1, 2, 3, 4, 5, 6, and 7 on the top of
the pre-assembled lower portion of your
upright pair.
FIGURE J
NOTE : Horizontal extrusion (G)
removed for clarity.
Micro display height intervals
labeled 1 - 7 along the outer
sleeve of each upright.
Secure micro display
height setting with single
wire snap pins (K) through
horizontal bracket holes
and uprights.
Slide horizontal brackets along sleeves until desired
micro height number shows through notch openings
(same number for both uprights).
Horizontal mounts positioned with
the set screws on the bottom.
FIGURE H
G