Page 25
POWERING THE TABLE BOXES
• Power your table boxes by running cables through tabletop(s), pedestals, and trough(s) as shown for
the following configurations. (
FIGURE AL and AM
)
NOTE
: To protect the wood finish from scratching, do not place any parts or tools on the unprotected
tabletop surface during assembly. For wood kit care and cleaning, refer to I-00788.
1. Install your power strip (T). For more information, see “Installing the Power Strip” on page 13.
(
FIGURE AL
)
2. Install your table boxes (AE). For more information, refer to the “A/V Table Boxes Installation
Instructions” 1011928.
1-Piece Tabletop Configuration Powering Two Table Boxes
CAUTION:
This topic shows how to connect your table boxes to the UL-listed ITE power strip(s) in
your table. While hardwiring is possible, it must only be done by qualified personnel following NEC,
NFPA 70, CEC, CSA C22.1, and all local municipal codes. Additional components are required for
hardwiring. Contact Middle Atlantic Products for more information at (
973) 839-1011.
ATTENTION:
Cette rubrique montre comment connecter vos boîtes de table à la (les) bande(s)
d'alimentation ITE (listée par UL) dans votre table. Tandis que le câblage direct de votre table
est possible, il ne doit être effectué que par du personnel qualifié selon NEC, NFPA 70, CEC,
CSA C22.1, et tous les codes municipaux locaux. Contactez Middle Atlantic Products pour plus
d'informations au (973) 839-1011.
Connect to desired receptacle in
over floor raceway or floor box.
FIGURE AL
AE
T
