Midas APOLLO QA018, Инструкция по монтажу

Страница: 4 / 25

3
MIDAS Group 2020
!
NOTE! Due to the fact that cabin walls are made of glass, mounting of these
elements ought to be conducted by at least two persons.
BEFORE YOU START MOUNTING REMEMBER THAT ALL MECHANICAL
CONNECTIONS BETWEEN STRUCTURAL ELEMENTS REQUIRE SEALING!
NOTE! The device must be installed in line with the binding law concerning electrical installations.
Electrical connection must be properly protected against water and moisture. Electrical connection should
have a residual current circuit breaker (RCD) with nominal
differential current not exceeding 30 mA. In
addition, the feed circuit must be equipped in a bipolar switch disconnecting electrical power of the cabin
NOTE! Connection of the cabin to the fixed installation of the room may be made using an installation
hermetic box with resistance class IPX4.
NOTE! In case of connecting the cabin to water installation use electrical leader hoses in metal shielding.
Hoses should be ended with 1/2 internal thread nuts”. The recommended nominal hose flow amounts to
15 l/min; the recommended nominal maximum operating pressure of the hose equals 4 bars.
You may use siphons available on the market in order to connect
the shower base outlet.
In line with the binding PN-EN 14527-2016 standards the maximum shower
base load amounts to 100 kg/m
2
.
SEALING OF SHOWER CABIN
When mounting the cabin, it is necessary to secure the key connection points of
the cabin walls, aluminium profiles, water connections etc. with a sanitary silicone.
Once mounting is complete, check the tightness of all connections.
The water cannot flow beyond the spray chamber of the cabin.
MOUNTING OF CABIN ON SHOWER BASE AND ALUMINIUM SLIDING SHEETS
After mounting of cabin walls and shower base you can proceed to mounting
additional accessories in the cabin, that is: glass shelf and handle inside the
shower cabin. Make sure that places of adapter torsions through the wall are
equipped in gaskets. The cabin must be sealed until all leakages stop.
The assembly of front fixed glass:
- Place the side, fixed glass on the mounted aluminium frame
- The glass should be supported by aluminium edges of the sliding sheet rolls
and fit into the cut-outs of side aluminium profiles
- screw the fixed glass delimiters by means of screws.
!
NOTE! In case of some cabins there is a possibility of taking down during
mounting the front shower base protection.
If silicone was used for sealing the outlet and siphon, remember that this
substance requires a specific duration, specified by its manufacturer, in order to
acquire the sealing properties.