- 4 -
4. Printing methods
Step 1: Make sure the cord is connected well to the wall socket. Place the object (i.e. T-shirt) on press bed, and
transfer paper with images facing down the object, adjust pressure to your requirement, and turn on the
power.
Step 2: Set the temperature and time required, then temperature starts to rise.
Step 3: When the temperature rise to the setting temperature, the buzzer sends out sounds. Press the two green
“Start Button” with both hands, then the heat platen close down automatically (meantime the sounds stop)
and starts to transfer.
Step 4: Then the time counter is on, once time is up, the upper heat platen will auto open.
Step 5: Consult the Transfer Paper instructions on whether to peel cold or hot, Here are suggested Pressing time
parameter for different transfer paper.
Ink-Jet Transfer Paper (fabric) 14-18 seconds
Laser Copier/Printer Transfer Paper (fabric) 18-25 seconds
Sublimation Transfers (onto Fabrics) 25-30 seconds
Sublimation Transfers (onto FR-Plastic/Woods) 60-70 seconds
4. Recommendations:
1) Ceramic tile transfer: (Mugs & Plates transfer is similar)
Set temperature: 180
℃
.
Set time: 15 seconds
2) T-shirt transfer:
Set temperature: 180
℃
.
Set time: (chemical fiber use for sublimation transfer paper: 30-50 seconds; pure cotton use for T-shirt
transfer paper: 10-20 seconds)
3) Aluminum sheet transfer:
Set temperature: 180
℃
Set time: 45 seconds
Emergency:
If any emergency happens, please press the red emergency stop button. After settled the emergency, please turn
the button clockwise and let it resume original status, and the machine will also resume working status.
NOTE:
1. Please switch off the machine power control valve if there is any problem.
2. The suitable air pressure is 0.4-0.5Mpa or 75-80Psi, neither too high (too high air pressure can destroy the
machine), nor too low (lower air pressure can’t let the heat platen work smoothly.)
3. Suggestion to power off for 1-2 hours after continuous working for 6-8 hours.
▲
. When you finish the transfer process, there are two important matters need attention.
4. Please don't shut down the power immediately, the heat platen is very hot now after long time working, please
press "OK" button after you finish the last heat transfer process, then the heat platen will stop heating, but the fan
in electronic box is still working, it helps cooling the hot heat platen. Please keep power for around 20-30 minutes
after you finish the transfer process.
5. Please don't shut down the air pump immediately, the heat platen is very hot now after long time working, if you
shut down the air pump, the hot heat platen will close and depress to under platen, it would burn the cotton pad.
Please keep air pump works for around 20-30 minutes after you finish the transfer process.
Содержание APD-20
Страница 7: ...7 VII Explosion View...
