Microtec APD-20, Руководство пользователя

Страница: 3 / 8

- 3 -
III. Operation Process
1. How to adjust the pressure:
1. Connect the heat press with air compressor or air sources.
2. Lift up the cap of air valve as the picture shown
3. Revolve the cap anticlockwise, the air pressure goes down; contrariwise, the air pressure goes up; when you
finish the pressure adjustment, push down the cap.
4. Suggested air pressure is 0.4~0.5Mpa/ 70-80Psi. It depends on the transfer materials.
2. Set temperature required
3. Set time required
Press button after
temperature setting and the
time light is
on. Select with arrows the
time according to different
transfer material.
Press button after time
setting; the display shows the
temperature starts to rise. “CD-L”
shows the time counting down
during your transfer.
If there is a difference between the actual
temperature and temperature shows on
the controller, you can use P5 mode to
calibrate the difference. For example,
when actual heat platen temperature is
180
°
C but the display shows 200
°
C,
press button for 5 seconds to enter the
P5 mode. When enter P5 mode, press
UP button
“△”
to set to- 20, and then
press button again for 5 seconds return
to operation mode. In the contrast,
when actual heat platen temperature is
200
°
C but the display shows 180
°
C,
press Down button
“▽”
to set to20, and
then press button 5 seconds return to
operation mode
Turn on power switch,
temperature light is ON. The
digital display shows
.
Press button, the light is
on (C denotes Celsius). Press
arrows “
△
” or “
▽
” to select “
℃
” or
“
℉
” (F denotes Fahrenheit)
according to your habits.
Press button, the temp light is on.
Select with arrows the temperature
according to different transfer material
(Normally
180
℃
~200
℃
)