DOC-iID-POCKETwork-02E.docx
Site 17 of 28
-
Connection management
o
Configuring the Bluetooth connection mode and MAC address,
profile numbers etc. for client mode
To configure the POCKETwork please connect it via Bluetooth or USB
cable to your PC, using Reader Connection Tool. Now start the iID
®
Interface config tool.
Note: If the POCKET was already switched from server mode to client
mode, the serial communication interface valid now is the incoming serial
port of your operating system. This can be seen in the previous section
under "Reading the COM ports".
The page with the main menu of the configuration tools now opens. In
addition, there is a status bar on the main page, where you can see the
battery status and the ID number (Reader-ID).
Now select the desired menu item. The current parameters are read from
the POCKET, which is indicated by a status bar in the menu button. Based
on your selection, the appropriate configuration dialog now opens. Below
the individual dialogues are briefly described:
Configuration of the visualisation and the one-off procedure:
