Micros Systems PCWS 2015, Руководство по установке

Страница: 70 / 178

3-2 PCWS 2015 Setup Guide - 2nd Edition
What’s Inside?
Disassembling the PCWS 2015
Disassembling the PCWS 2015
The following procedure describes how to disassemble the unit and access the
system board and peripheral components.
1. Remove all cables from the IO Panel including the AC Power cable before
disassembling the unit.
2. Place a towel or other soft cloth on you work surface to protect the
touchscreen, then place the workstation face down on this surface. If an
option such as the Finger Print reader is attached to the front cover, take
care not to rest the workstation on the housing.
o The cover is held in place by a pair of captive screws assessable from
the underside of the unit as shown in Figure 3-1.
3. Loosen the captive screws as shown. Return the unit to the normal
operating position. Remove the top cover from the base by lifting at the
front as shown in the lower half of Figure 3-1.
Figure 3-1: Removing the Top Cover
4. Remove the screw that fastens the LCD/Touchscreen assembly to the base
as shown at the top of Figure 3-2.
CAUTION: DOUBLE POLE/NEUTRAL FILTERING
The PCWS 2015 Power Supply contains a permanently
connected fuse in the neutral line. After fuse operation, parts
of the power supply remain energized and present a shock
hazard as long as the AC Power Cord is connected.
Always disconnect the AC power cord before opening the unit
for service or configuration.