Also give the sides of the canopy a light
sanding
–
just a few strokes of the
sanding block to smooth off the sides.
Insert the canopy to make sure it fits firmly but
not too tight. Sand more if needed.
If you intend to apply stickers to the
sides of the fuselage then now is a
good time to do this before attaching
the wing tips and control surfaces.
Using a hobby knife to position the stickers is
easier than using your fingers.
Also attach the caution stickers as shown here.
These stickers actually protect the foam from
prop strike when landing if you are using a prop
saver.
Identify where the air dams attach and run
some glue along the line on top and bottom of
the wings and around the front of the wings.
The air dams can be twisted a little to slip them
over the wing and into position.
Look from the front of the wing to ensure they
are straight and wipe off any excess glue.
Video Link
Video Link
Video Link
