9
2.3.2.3 Gigabit LED
The Gigabit ports support 1000BASE-T media connection and diagnostic
LEDs. There are five LEDs for gigabit switching port including 10M, 100M,
1000M, FDX, Link/ACT.
2.4 The Rear Panel
The rear panel of the hub is shown below
2.4.1 Power Connecting
For compatibility with electric service in most areas of the world, the
switching hub’s power supply automatically adjusts to line power in the range
100~240 VAC and 50~60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear
panel of the switching hub. Plug the other end of the power cord into an electric
service outlet then the power will be ready.
2.4.2 Console Port
Through the console port, it provides rich diagnostic information includes
network statistics, link status and system setting. The operating mode of the
console port is:
DCE (terminal mode)
9600 (baud rate)
N (non-stop bit)
8 (8 data bits)
1 (1 parity bit)
You could use a normal RS-232 cable connect to the console port on the
device. After the connection, you could run any terminal emulation program
(Winterm, Telix, … and so on) to enter the startup screen of the device. All the
detail software operation, please refer to “Console Program” session.
