Micron Ulva+, Инструкция по эксплуатации

Страница: 5 / 24

3
PREPARING FOR SPRAYING
The sprayer is delivered in a collapsed form pre-set for use with a particular number
of batteries N.B. five batteries are recommended for use with water-based products,
six to eight for ULV formulations. To assemble ready for spraying:
1) Remove the atomiser protective cover and check by hand that the atomiser disc
spins freely. Extend the sprayer and screw the one litre bottle onto the spray
head.
Do not overtighten. Make sure the red cap or refilling point is in line with
the extension tube. Instructions on assembling Micron Micropak backpacks are
contained inside the tank. N.B. the feed tube from the Micropak must be securely
connected to the flow valve which should be fitted into the valve retaining clamp
on the battery case and the hose connections secured with the clips supplied. The
tubing on the sprayer should be clipped into the large hole on the battery case end
cap and attached to the flow valve.
2) Remove the switch end piece as
shown on the label.
3) Insert the required number of
batteries (D-cell/R20) negative, i.e.
flat, end first.
N.B. Battery condition should always be checked before use, either in a torch or
using a torch lightbulb and electric wire – see ‘TROUBLESHOOTING’. Before
spraying for the first time with the ULVA+, sprayer operation should be checked
using
only water (see ‘BEFORE SPRAYING’).