22
- Lamp off via DMX
This function allows you to switch off the lamp by DMX. Use the
[Up]
and
[Down]
keys to select
"On"
if you
want to switch off the lamp by DMX or
"Off"
if you don’t want to switch off the lamp by DMX and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu
.
- Temperature
Inside temperature readouts of the fixture in Celsius. Inside temperatures below 66° C are not critical. 66° C and
more lead to the lamp being switched off. Please note that the outside temperature should not exceed 40° C.
- Fan speed operating
By using this function you can choose 4 types of fan speed operating. Browse through this menu by the pressing
[Up]
and
[Down]
keys - the display shows step by step the following messages:
"HIGH, reG, Lo.HI, Lo.OF
".
Press
[Enter]
if you wish to select one of them or
[Mode]
to cancel and return to the menu.
- high speed of the fans
The cooling fans work on max. speed (max. cooling).
- continuous controlling of the fan speed
The fan automatically raises its speed in order to control inside
temperature of the lighting, if the temperature inside increases
about certain level (the low fan speed reduces the cooling of the
lighting). This cycle can repeat several times until the temperature
inside is on a suitable level.
low /high speed of the fan operating
The fan keeps the adjusted low speed until the temperature exceeds max. inside temp. of the fixture, then the
ULTRA SPOT
automatically switches from low to high fan-speed.
- low speed / switch off the lamp operating
The fan keeps the adjusted low speed until the temperature exceeds max. inside temp. then the
ULTRA SPOT
automatically switches off the lamp
.
- Default settings
Press
[Enter]
to reset all fixture personalities (not the
adjusting functions) to the default values. On the display
will appear,
“rSt”
meaning that the fixture makes the
reset. See the table of personality setting and their de-
fault positions.
7
ENGLISH
2. SAFETY
2.1 Safety instructions
This device has left our premises in absolutely perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessary for the user to follow
the safety instructions and warning notes written in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject
to warranty.
The dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation),
do not switch it on immediately. The arising condensation water might damage your device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. The power plug must only be plugged into a pro-
tection class I outlet.
Never let the power-cord come into contact with other cables! Handle the power-cord and
all connections to the power supply with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the
device and the power-cord from time to time.
Always disconnect from the power supply, when the device is not in use or before cleaning
it. Only handle the power-cord by the plug. Never pull out the plug by tugging the power-
cord.
During the initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective.
Caution:
During the operation, the housing becomes very hot.
Do not switch the device on and off in short intervals as this would reduce the lamp’s life.
Please consider that damages caused by manual modifications to the device are not sub-
ject to warranty.
Keep away children and amateurs!
CAUTION !
Be careful with your operations.
With a dangerous voltage you can suffer a
dangerous electric shock when touching the wires!
HEALTH HAZARD!
Never look directly into the light source, as sensitive persons
may suffer an epileptic shock (especially meant for epileptics)!
