6
1.3 Photometrics
23
ENGLISH
- Adjusting the default positions of colour, gobo and effect wheels
By this function you can calibrate and adjust the colour, gobo and effect wheels to their standard/right positions.
Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these
messages:
"PAn, Tilt, SPEd, Col1, Col2, PriS, SGob, rGob, Grot, IriS, Foc, Stro, dimr, FCAL"
by which you
can adjust the fixture to the required / desired position (0-255) before the function calibration.
Then when the positioning is finished use the last
"FCAL"
function (Fixture calibration).
1. Calibration via the control board
Press
[Enter]
and the
[Up]
and
[Down]
keys in order to display the following messages:
"Col1, Col2, PriS,
SGob, rGob, Grot"
for very smooth function calibration. Select one of them, press
[Enter]
and use the
[Up]
and
[Down]
keys in order to adjust their right value from 0 to 255. Then press
[Enter]
to confirm or
[Mode]
to
cancel and return to the menu. This can be repeated for each calibration parameter if it is required. When the
calibration is finished, it is necessary to use the
"ArES"
function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the newly adjusted positions of the colour gobo and
effect wheels. When the reset of the fixture is finished, the display will show the
"FCAL"
message.
Press
[Enter]
to repeat the calibration or
[Mode]
to return to the
"AdJ"
menu.
2. Calibration via the external controller
Press
[Enter]
and the
[Up]
and
[Down]
keys in order to display the following messages:
"Colo, EFEC, rGob,
Grot"
- calibration parameters. Select one of them and press
[Enter
].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
DMX Calibration protocol:
After having calibrated required functions press
[Enter]
to confirm (or
[Mode]
to cancel and return
to the menu without reset by the
"ArES"
function) and use the
"ArES"
function in order to write the
calibration values to the memory (EEPROM) and to make a reset in order to check the new ad-
justed positions of the colour, effect and rot. gobo wheels and gobo indexing.
8. ERROR AND INFORMATION MESSAGES
This message appears if you try to switch on the lamp within 5 minutes after having switched
it off (the lamp is too hot). The message will appear on the display if the lamp doesn't ignite within
28 seconds. The
MICROH ARENA ULTRA SPOT
will store this information and automatically ig-
nite the lamp when the 5 minutes period has expired.
