MicroCool BIGHORN 1000, Инструкция по установке и обслуживанию

Страница: 20 / 36

BIGHORN_March 2020.docx
March 26, 2020 Page
20 of 36
Figure 7 – Suspended Aircraft Cable and Atomization Line
RATCHET STRAINER/ AIRCRAFT CABLE
POLE/ COLUMN POLE/ COLUMN
AIRCRAFT CABLE
ATOMIZATION LINE
AUTOMATIC DRAIN VALVE
Figure 8 – Supporting Atomization Line at Mid-Span
ROOF STRUCTURE
VERTICAL SUPPORTS
ATOMIZATION LINE
12. The weight of the atomization lines may cause the Aircraft Cable to sag. To overcome sagging it is necessary
to support the atomization line along its length. In the diagram below, short lengths of Aircraft Cable have been
attached to a roof structure and then dropped and fixed to the Aircraft Cable supporting the atomization line at
an interval of 10 to 15 feet. (3 to 4.5 MT). Please refer to figure 6. Always consider line drainage when
suspending overhead atomization lines.
15.4 SPECIAL CONSIDERATIONS:
Do not attempt to install lines without intermediate support.
***NOTE: When wrapping flexible atomization line or manifold around a corner or coming to the end of a
long run, leave approx. 4” to 6” extra per 10 foot of manifold line to account for possible line shrinkage.
Failure to do so will result in line or fitting leakage or damage. See page 13, figure 9a for more
information.