MicroCool BIGHORN 1000, Инструкция по установке и обслуживанию

Страница: 17 / 36

BIGHORN_March 2020.docx
March 26, 2020 Page
17 of 36
14.1
INSTALLATION INSTRUCTIONS—TUBE FITTINGS
For proper fitting performance, the tubing surface finish should be clean, free from nicks or scratches. Do not use
out-of-round tubing, which does not easily go through fitting components.
NOTE: These instructions apply to traditional fittings and fittings with the
advanced back ferrule geometry.
Insert tubing into the compression tube fitting (Fig. 1).
Make sure that the tubing rests firmly on the shoulder of the tube fitting body
and that the nut is finger-tight.
Scribe the nut at the 6 o’clock position (Fig. 2).
While holding fitting body steady, tighten the nut 1 1/4 turns to the 9 o’clock
position. (Fig. 3)
14.2 INSTALLATION INSTRUCTIONS-TUBE BENDING
The stainless steel tubing may be bent to fit around objects with a tubing
bender. MicroCool tool part# TKT0012 may be used or you may obtain one
locally.
Figures 1-3.