Microcom 428T, Руководство оператора

Страница: 116 / 249

Printer Commands Chapter 5
5-42 428T Operator’s Manual - 880037-0141
5.5.1 Au Form Feed
This command is useful to load media without having to press the Print Button to start
printing again. The operator must insert the label stock into the printer until it stops against
the drive roller. The printer will automatically begin to turn the drive roller after the stock is
sensed by the transmissive sensor. A delay (^D120) may be set from when the stock is first
sensed and when the drive roller starts to turn. The printer will advance a blank label,
based on the current or last processed label, before starting to print properly registered
labels.
These are the steps for Au FF:
1. With the head mechanism latched in its normal print position, the user
inserts new media until it stops at the drive roller.
2. The printer senses the new media and waits the programmable amount of
time set by the ^D120 command (default is 1.5 seconds).
3. After the ^D120 time delay, the printer advances the media until the first
registration mark is sensed based on the current or previously executed
form size.
4. Label printing will resume if a job is pending.
Set ^D25 bit #6 to “1” to enable the use of Au Form Feed.
The Au FF may be used in conjunction with a saved format that acts as a template
for the form size used by the autoload feature. This method assures that the correct form
size used is loaded at power up enabling the autoload feature to be used when the printer is
powered on before sending print jobs. The saved format or template is typically a format
with the header configured for the media size/type being used and is configured to not print
automatically. Below is an example of a format that is being saved into memory that is used
as an autoload template and sent to the printer as part of the printer’s configuration.
AFF power up format example:
^A1^D131<CR>
(Deletes data saved into memory slot 1)
^A1^D130<CR> (Save format into slot 1)
^D57 <CR> (A label format is coming.)
1,1280,900,19,38,7,0,1,385,0,0 <CR> (Header Information.)
1,1,1,,6,,,,1,1,,,,,0 <CR> (Field #1 format information (line draw).)
^D56 <CR> (Signals the end of the label field definition.)
^D2 <CR> (Text data is coming.)
. <CR> (Text data string #1.)
^[ <CR> (Used to mark the end of save format)
This would example saves the format into Flash memory slot 1. This format stored in slot 1
may know be selected as a power-up format that will be processed every time the printer is
power on. This is accomplished by using the ^D21 command bits 5-8; ^ABxxxx1001^D21.
It should be noted that the format example does not contain a print command. This is done
this way so that the saved template does not automatically execute when the printer is
turned on. Basically, the printer powers up and processes the format and is awaiting a print
request before executing the stored label. When using this as an autoload template, the