COPYWRITER PRO SERIES DUPLICATOR MICROBOARDS TECHNOLOGY, LLC
Unpacking your system
When unpacking your duplicator, confirm the following items are included:
•
CopyWriter Pro Series duplicator
•
Power cable
•
Quick Start Guide
•
Microboards Documentation CD
•
Blank CD-R media
If any of these items are missing, please contact your distributor or Microboards
Technology Technical Support at 952-556-1639.
IMPORTANT:
Please keep all the packing for your CopyWriter Pro duplicator. If your
unit ever needs to be sent in for service, it must be returned in the original packing or the
warranty will be voided.
Installation Requirements
System Setup
•
Connect the power cable to the CopyWriter Pro tower and plug in to a protected power outlet
strip or UPS power supply.
•
Turn on power to the tower. The system is now ready to use.
Install your CopyWriter Pro duplicator in the following conditions:
•
On a level and stable surface
•
In a well ventilated location
•
Temperature and humidity
•
Temperature: 5-40
°
•
Humidity: 20-80%RH (no dew formation)
Do not install it in the following places:
Under direct sunlight (If the machine is exposed to sunlight, the light should be
blocked by a curtain or blind.)
A dusty location
A place where there is a lot of vibration
Near open flame
A place where the temperature and humidity change drastically
Near a heating device such as a heater or furnace
A location where air from an air conditioner blows directly onto the unit
Near a container filled with water such as a vase
In winter during times of low humidity or in a location where static electricity is
generated, use an anti-static-electricity mat or humidifier to prevent static electricity
.
4
