micro-trak MT-3405F II, Справочное руководство

Страница: 21 / 62

21
Special calibration mode is used to set up system
parameters that rarely need to be changed or adjusted.
To enter Special Cal, put the system in HOLD, turn the
console OFF, press and hold both the AUTO/MAN button
and CAL button while turning console ON. The console
will display SPEC for 2 seconds to show that the console is
in the Special Calibration mode. Release the AUTO/MAN
NOTE: The following table describes the “Special” Cal
parameters and shows the factory settings. More detailed
descriptions follow the table.
Special Calibration
Parameter Description Factory Setting
Units System of Units EnG (English) or mEt (Metric) / TurF (Turf) EnG (English)
Valve Voltage Servo Valve Drive Voltage (8/12) 12
Material Choose Liquid (H2O) or Anhydrous (NH3) H2O
Valve Response Speed Set Valve Response (-4 to 3) -1
Fill Tank Size Size (volume) of Full Tank (Off or 1-65,535) Off
Tank (Low) Set Point Sets Alarm Set Point if using TANK Function (Off or 1-65,535) Off
Auto Shut-off Runs Servo Toward Minimum when in Hold (On/Off) Off
Auto Delay Time
Delay Servo Response when going from Hold to Run (Off to 4 sec.)
Allows slow shutoff valves enough time to open before adjusting servo
1
WIDTH
CAL
FLOW
CAL
MIN
FLOW
ADJUST
RATE
TARGET
RATE
SPEED
CAL
INLINE
BYPASS
TEST
SPEED
VOLUME /
MINUTE
DISTANCE
AREA /
HOUR
VOLUME
(1) (2) (3)
RATE SPEED
AREA
(1) (2) (3)
CAL
AUTO
MAN
RESET
____
TANK
___
AUTO
1
Special Cal Special Cal
Fill Tank Size
Tank Set Point
Auto Shut-off On/Off
Auto Delay Time
Units
Valve Voltage
Material
Valve Response Speed
and CAL buttons. The CAL icon and Warn LED will turn on.
The desired Special Calibration parameter(s) can then be
accessed with the rotary switch per the illustration below.
To exit Special Calibration, press and hold the CAL button
for 2 seconds. The console will store any changes and
revert to normal operation.
NOTE: you must exit Special Calibration to save changes.