Micro-Mega 20138501 N, Руководство по эксплуатации

Страница: 6 / 48

6
HEROfill ® Oven Operating Instructions
Classification
The HEROfill
®
Oven is a Class I medical device, in compliance with MDD (Medical Devices Directive
93/42/EEC) Section IX.
The heater must only be used in dental clinics by dental personnel, and only for heating the HEROfill
®
Obturator. The product is classified according to DS EN 61010-1-2010 and thereforemust not be
used within reach of patients.
The HEROfill ® Oven has a heat chamber that consists of 5 printed circuit boards with copper lanes. By
applying power to the copper lanes heat is generated.
The oven is driven by an external power supply.
Warning
Do not touch the inside of the heat chamber before the oven is completely cooled.
The Heater must be used for its intended purpose and is protected from overheating by two
independent circuits.
Technical specifications
POWER SUPPLY
Input power 100-240V AC, 50/60Hz
Output power 9V DC, 1.7A
SAFETY
Auto turn off The heater turns off automatically after 9
hours
(Normal) Environmental conditions
This standard applies to equipment designed to be safe at least under the following conditions:
a) indoor use;
b) altitude up to 2000 m;
c) temperature 5
o
C to 40
o
C;
d) maximum relative humidity 80% for temperatures up to 31
o
C decreasing linearly
to 50% humidity at 40
o
C;
e) Mains supply fluctu 10% of normal voltage;
f) Overvoltage Category II;
g) Temporary overvoltages occuring on the mains supply;
h) Pollution degree 2
Heating times
HEROfill
®
Obturator heating time is 60 seconds.
Preheating of the heater takes 3-4 minutes depending on surrounding temperature.
1. Start using the heater
1. Connect the power supply to the DC inlet of the heater and the mains and switch on power (B1).
2. Indicator A emits a red light while the HEROfill ® Oven preheats (B2) . When the HEROfill ® Oven is
ready, the indicator emits a green light, and you will hear a beep.
Notice: The HEROfill ® Oven can be left on the entire day.
The HEROfill ® Oven must only be serviced
and repaired by MICRO-MEGA ® or an approved dealer
otherwise the warranty will be void.