MICRO-EPSILON surfaceCONTROL SC2500, Руководство по эксплуатации

Страница: 36 / 42

Page 36
Appendix | GenICam surfaceCONTROL Parameters | Version 1.5
surfaceCONTROL 3D SC2500 / SC2510
Name Description Documentation Text
ImageOffset[SourceSelector]
[ComponentSelector] 2D Mode components
only: Offset Offset for the gray values of the [Amplitude], [Curvature] and [Base]
components.
Acquisition Control
AcquisitionMode
Sets the acquisition mode
of the device. Sets the mode for 3D image acquisition.
SingleFrame - single measurement, must be stopped using Acquisi-
tionStop) (repeated measurement requires repeated AcquisitionStart).
Continuous - continuous image acquisition (after AcquisitionStart) is
performed until AcquisitionStop occurs.
AcquisitionStart Starts the Acquisition of
the device. Starts image acquisition. If TriggerMode = Off, image acquisition starts
immediately. If TriggerMode = On, the system waits for a trigger event.
AcquisitionStop Stops the Acquisition of
the device at the end of
the current Frame. Stops image acquisition once the current 3D frame has been transmit-
ted in its entirety.
TriggerMode[TriggerSelector] Controls if the selected
trigger is active. Enables trigger mode.
TriggerSoftware
[TriggerSelector] Generates an internal trig-
ger. TriggerSource must
be set to Software. Command to trigger a measurement.
TriggerSource
[TriggerSelector] Specifies the internal
signal or physical input
Line to use as the trigger
source. Source of trigger signal. Available are Software (software trigger using
Genicam command) and Line1 (hardware trigger from Input Line1).
TriggerActivation
[TriggerSelector] Specifies the activation
mode of the trigger. Sets whether the rising or falling slope of the trigger signal (only hard-
ware trigger) is used to trigger a measurement.
ExposureTime Sets the Exposure time in
Microseconds. The exposure time of the cameras in [µs].
PatternDisplay Defines the pattern that is
shown during live stream. Selects the image to be projected by the projector for live image
operation.
The following entries are available:
- Bright image
- Off
- Fringe pattern
- Positioning aid
MultiSlopeMode Controls multi-slope expo-
sure state.
MultiSlopeKneePointCount The number of knee-
points as well as the
number of additional
exposure slopes used for
multi-slope exposure.
MultiSlopeKneePointSelector Selects the parameters
for controlling an addi-
tional slope in multi-slope
exposure.
MultiSlopeExposureLimit
[MultiSlopeKneePointSelector] Percent of the Expo-
sureTime at a certain
knee-point of multi-slope
exposure.