EDM-MD Series
Installation Manual
Page 12
3.4 Mounting Doors
-
Position hanger roller brackets on top of door leaf.
-
Ensure hanger brackets are aligned, then secure in place.
-
Loosen hanger bracket retainer to mount doors on rail.
-
Mount doors on rail.
-
Adjust and secure hanger bracket retainer 2mm from underside of base rail.
-
Adjust door height for floor clearance.
-
Check door alignment to eliminate gaps before tightening fully.
3.5 Smooth Operation
-
Check opening and closing of door leaf with power off.
-
Doors must run smoothly without friction or noise.
-
Doors should be easy to push open and close.
-
Check clearance from finished floor level (open & close).
3.6 Power On
Caution – Before switching the power on:
-
Rail and doors are correctly installed
-
Ensure tooth belt is tightened
-
Main parts are correctly installed - Refer to wiring diagrams. Sec. 8.
The power switch is located to the right of motor fixed to the underside of the base rail.
4. Teaching / Learning Operation
CAUTION: Ensure that the door travel area is clear before pressing RESET in order to memorize the
door stroke.
4.1
Teaching / Learning
After installation is completed, in order to memorize the door stroke by a teaching or learning stoke. The following
steps are required.
-
Set the slide switch (Prog / Run) down to “PROG”.
-
Press and hold the “UP” button & “SET” button together. The RED and GREEN LED will flash once the RESET
is complete.
-
Set the slide switch up to “RUN” and the door will start to close at low speed.
Starting from the fully closed position will ensure the doors are correctly optimised.
-
From the fully closed position, the door/s will open at low speed.
Here EDM MD controller is memorizing the stroke by this cycle. Once at full open, the teaching / learning
stroke is complete. The door/s will then close at normal speed.
