
18
86D0024
INSTALLING vENTED APPLICATIONS
PLACING AND SECuRING APPLIANCE
ASSEMBLY PROCEDuRE:
1. Center the gas log unit on the ireplace or irebox. Make certain the front of the burner sits
inside the front edge of the ireplace or irebox.
2. Anchor holes are located on the right and left sides of the unit. After centering the burner cor-
rectly, mark the hole positions on the ireplace/irebox loor. Drill two (2) 5/32" diameter holes
approximately 1
1
/
2
" deep.
3. Anchor the burner to the ireplace/irebox loor using the screws provided.
Figure 13
Proper installation of the heater is essential to prevent any movement of the gas logs and
controls during operation.
Figure 13 - Secure Heater to Floor of Fireplace/Firebox
Screw
Anchor Hole
Screw
W
A
R
N
IN
G
You must secure the gas log heater to the ireplace loor. If not, the entire unit may move
when you adjust the controls. Movement of unit may cause shifting of the gas logs which
leads to sooting and improper burning. Grate movement could cause a gas leak.
Special care is required if you are installing the unit into a sunken ireplace. You must raise
the ireplace loor to allow access to gas log controls. This will insure adequate air low
and guard against sooting. Raise the ireplace loor using noncombustible materials, as
described in Placement in a Fireplace with Restrictive Barrier on Page 10.
FP2006