MHS Boilers XenoROL XR40, Инструкция по установке, эксплуатации и обслуживанию, Страница: 30 / 84

XenoROL®
30
2. Place the end plate of the spur against the
side channel of the abutting bed and mark
the location of the mounting bolts on the
frame of the abutting bed.
3. Drill 13/32" diameter holes in the side
channel of the channel where marked. (The
number of holes is determined by the width
of the spur.)
4. Remove the mounting bolts, in the end plate
of the spur, and attach the spur to the bed.
Leave the spacers on the mounting bolts.
These spacers go between the channel and
the spur end plate.
5. Check the spur elevation and tighten the
bolts.
TRAFFIC CONTROLLER
Traffic Controllers are used where two powered
conveyors converge to prevent interference of
products at the merge point on a first come first
serve basis. The arms are bolted to the upper
pivoting plate to be parallel with the rollers in the
merging conveyors. The body of the traffic controller
is mounted to the conveyor frames in a position
which splits the angular difference between the
frames. Ref. illustration. It is mounted by bolting the
bottom plate to the bottom flanges of 4-1/2" deep
channel frames or to the adaptor angles used with 9"
deep frames. Reference the illustration.
Guard rails (angle or adjustable channel) are
recommended on both sides of each conveyor.
Conveyor rollers may be skewed upstream on each
conveyor, as required, to align products along one
side. This is important when conveying varying size
products to prevent them from getting side by side if
a backup occurs against one arm. Tip: Light
products will push through the arms easier if skewed
away from the traffic controller (toward the arm tip)
to gain leverage.
XENOSWITCH ASSEMBLY
The XenoSWITCH transfers product off a main line
to a spur at 30°. The switching must be done in a
gap of at least 30" between products. The switch
works best when the product is aligned to the spur
side as it approaches the switch. Minimum product
size is 9" x 12".
The XenoSWITCH is assembled at the factory and
consists of a switch bed with pivoting switch frame,
air cylinder and attached spur with power connection
which continues the drive between the spur and
switch bed.
The switch frame must rotate between products (not
under any product). The XenoSWITCH is best used
to divert several cases between switching. The
XenoSWITCH is not a sortation device except for
under ten products per minute.
The XenoSWITCH assembly is installed in the
conveyor system using any of the standard
supporting arrangements. When the switch frame
rollers rotate, a gap is created between the switch
and spur rollers. This may cause some product, with
weak or flexible bottoms, to catch on the ends of the
spur rollers. This situation may be alleviated by
loosening the bolts that secure the spur to the switch
bed and lowering the spur so the switch bed rollers
are slightly higher than the spur rollers. Tighten the
bolts after this adjustment is made.
For proper operation, use a minimum of 70-90 PSI
air pressure to the XenoSWITCH cylinder.
90480006rev092010