M6 x 55 Hex Head Bolt
M10 x 60 Hex Head Bolt
M10 Nyloc
M10 Spring
Washer
M6 Washer
M6 Nyloc
DETAIL, S
SCALE: 1 : 2.5
M6 Bolt Cap
M10 Bolt Cap
DETAIL, T
SCALE: 1 : 2.5
DETAIL, U
SCALE: 1 : 2.5
DETAIL, V
SCALE: 1 : 2.5
S
T
U
V
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
A
A
B
B
C
C
D
D
E
E
F
F
G
G
H
H
SHEET
6 OF
8
REVISION
1
Instructions for ALL
Folding Goals
MH Goals Ltd,
Ellough Industrial Estate,
Beccles, Suffolk,
NR34 7TD
Parts Required
Step 4 -
Take the net support assembly from step 3, using Details S & U as a guide and Details T & V as how it should end up.
Place one into each side of the goal frame, lining the holes in the ends of the net support up with with the hole and slot of the hinge brackets.
For the top bracket fix the net support in place by putting one of the supplied M10 washers over the M10 x 60 hex head bolt. From the top of the bracket put the bolt through
the bracket and net support, fasten using another M10 washer along with an M10 nyloc - See Detail S.
Then take the M6 x 55 hex head bolt, place an M6 washer over the bolt. Place the M6 bolt through the slotted section of the bracket, with the bolt facing downwards, then
place another M6 washer over the other end of the bolt and fastening into place with the supplied M6 nyloc -
See Detail S.
For the bottom bracket, repeat the process for the top bracket but this time place the bolt through from the bottom of the bracket - See Detail U.
Once the net supports are in position place the bolt caps over the nuts and the section of bolt that is sticking out, see Details S & U.