3. Operations
Network
The Network configuration page is used for maintenance of the network interface. From this page an
administrator may configure the IP address, subnet mask and gateway address as well as view the link status,
speed and duplex value.
The AmpMeter PDU is configured with the following network defaults to allow unit configuration out-of-the-box
through either Telnet or HTML:
•
IP address:
192.168.1.254
•
Subnet Mask:
255.255.255.0
•
Gateway:
192.168.1.1
The initial local PC network connection must be configured as noted below:
NOTE: Contact your system administrator for instructions in reconfiguring the network connection.
Reconfiguration of your network connection may require a restart to take effect.
•
IP address:
192.168.1.x (where x is 2-253)
•
Subnet Mask:
255.255.255.0
NOTE: The unit must be restarted after network configuration changes.
See
Performing a warm boot:
on page 17.
Setting the IP address, subnet mask or gateway:
In the appropriate field, enter the IP address, subnet mask or gateway address and press
Apply
.
Telnet/SSH
The Telnet/SSH configuration page used to enable or disable Telnet and SSH support and configure the port
number that the Telnet or SSH server watches. For more information on SSH see page 35.
Enabling or disabling Telnet or SSH support:
Select
Enabled
or
Disabled
from the appropriate Server drop-down menu and press
Apply
.
Changing the Telnet or SSH server port number:
In the appropriate Port field, enter the port number and press
Apply
.
HTTP/SSL
The HTTP/SSL configuration page used to enable or disable HTTP and SSL support, configure the port number
that the HTTP server watches and responds to, selection of the method of authentication used and SSL access
level. For more information on SSL see page 34 in.
Enabling or disabling HTTP or SSL support:
Select
Enabled
or
Disabled
from the appropriate Server drop-down menu and press
Apply
.
Changing the HTTP server port number:
In the HTTP Port field, enter the port number and press
Apply
.
301-0399-3 Rev A. - Page 13
