3. Operations
Displaying serial port information
The Show Ports command displays information about all serial ports. This information includes:
•
Serial port data rate
•
Descriptive port name, if applicable
•
DSR signal checking settings
To display serial port information:
At the AmpMeter PDU: prompt, type
show ports
and press
Enter
.
Example
The following command displays all serial port information:
AmpMeter PDU: show ports<Enter>
Serial Port Configuration
ALL Ports:
Baud Rate: 38400
Console Port:
DSR Check: ON
System Administration
Creating a location description
The Set Location command specifies text that appears in the HTML control screen’s Location field. The text is
also appended to a Welcome to banner that appears when a user successfully logs in serially or through a
Telnet session.
If you do not issue this command, or if you issue this command without specifying any text, the control screen ’s
Location field will be blank and no Welcome to banner will be displayed.
To create a location description:
At the AmpMeter PDU: prompt, type
set location
, followed by a descriptive name of up to 24 alphanumeric
and other typeable characters (ASCII 32 to 126 decimal - spaces are allowed). Press
Enter
.
Omitting any characters after typing ‘set location’ deletes any previously specified text.
Examples
The following command specifies Florida HQ as the descriptive location for the control screen and the login
banner:
AmpMeter PDU: set location Florida HQ<Enter>
The following command deletes any previously specified location description:
AmpMeter PDU: set location<Enter>
In this case, the control screen’s Location field will be blank, and no welcome banner will be displayed after a
successful login.
Page 26 - 301-0399-3 Rev A.
