mFi Mason-Lite MGFPST-43A Скачать руководство пользователя страница 3

1

CONTENTS

Below is a sample picture of the rating plate that is located inside the lower dome side of your fireplace. Serial number and date 

code should be stamped on the plate where required.

NG

LP

7. HOLES: 4X Ø 0.14” THRU

6. CLEAR BOXES NEXT TO MODEL NUMBERS ARE TO BE STAMPED DURING MANUFACTURE OF FIREPLACE.

5. LARGE TEXT TO BOLD UPPERCASE ARIAL, 10 PT. MIN. (WHERE SHOWN).

4. SMALLEST TEXT TO BE ARIAL, 8 PT. MIN (WHERE SHOWN).

3. ALL TEXT AND GRAPHICS TO BE BLACK ON A CONTRASTING, CLEAR ALUMINUM BACKGROUND.

2. FINISH: CLEAR, PROTECTIVE COATING AT RATED TEMPERATURE IN NOTE 1.

1. MATERIAL:  CLASS IIIA , .024 THICK ALUMINUM RATED AT 302°F (150°C).

NOTES

: (UNLESS OTHERWISE SPECIFIED)

DESCRIPTION:   LABEL, RATING, MGFPST43

P/N: MFP588

REV: B

DATE: 02/16/2015

LAST MODIFIED BY: CB

Doc File Name: MFP588B_RATING PLATE, MGFPST43

PFS

®

US

4.25”

4.00”

6.5”

6.25”

.12”

DATE OF MFG.

SERIAL No.

This appliance is not for installation in manufactured or mobile homes.

    MFP588 rev

.B

GAS 

TYPE:

FOR MANTEL CLEARANCES 

CONSULT OWNER’S MANUAL

DO NOT REMOVE THIS LABEL

See MFI’s installation and operating instructions for this 

model. Contact local building officials about restrictions 

and  installation specifications in your area.

     THIS FIREPLACE IS DESIGNED 

FOR USE ONLY WITH THE ANSI 

Z21.50 DECORATIVE GAS LOGS 

AND BURNER TESTED AND 

APPROVED FOR THIS FIREPLACE.

Consult instructions included with this 

firebox for further information.

!

 

      

 

WARNING:

Use only approved, listed chimneys

12” B-Type Vent and DM-12-12” system, 

UL 103 chimney or a 12” class A 

chimney if preferred.

Chimney Heights:

Max.: 40 ft.

Min.: 14 ft. (17 ft. with 1 or 2 offset 

sections maximum)

IMPORTANT: Refer to pipe 

manufacturer’s instructions.

       

WARNING:

THIS FIREPLACE HAS  BEEN TESTED 

FOR USE ONLY WITH APPROVED  

GLASS DOORS. TO REDUCE THE 

RISK OF FIRE OR INJURY, CONSULT 

OWNER’S MANUAL.

THIS APPLIANCE NEEDS FRESH AIR FOR SAFE OPERATION AND MUST BE INSTALLED 

SO THERE ARE PROVISIONS FOR ADEQUATE COMBUSTION AND VENTILATION AIR.

!

WARNING:

  THIS FIREPLACE IS NOT INTENDED FOR BURNING SOLID FUELS.

!

WARNING:

  

This gas appliance must not be connected to a chimney fuel servicing a solid fuel burning appliance.

!

FIREPLACE CLEARANCES TO COMBUSTIBLES:

UNIT FRONT, SIDES, REAR...............................

0” (0 mm)

COMBUSTIBLE FLOOR......................................

0” (0 mm)

COMB. SHEATHING ABOVE OPENING TOP.....

8”

 (200 mm)

SHEATHING OR TRIM TO OPENING SIDES....12“ (300 mm)

OPENING TO SIDE WALL..................................20

 (500 mm)

HEARTH EXTENSION BEYOND SIDES............12“ (300 mm)

INSULATION FROM FIREBOX............................

0”  

(0 mm)

The installation, including provisions for combustion, ventilation air, and required minimum permanent vent opening,

must conform with the National Fuel Gas Code (ANSI Z223.1/NFPA 54) and applicable local building codes.

MODEL

  No.:

MGFPST-43

MFI

Masonry

Fireplace

Industries, LLC

6391 Jurupa Ave.

Riverside, CA 92514

LARR No. 25924

Tested & Listed By

Report No.

 08-154

Fireplace Parts List

 .......................................................... 3

Fireplace Overall Dimensions

.......................................... 4

Fireplace Framing Dimensions

 ........................................ 4

Burner and Logs Parts List

 .............................................. 5

Important Pre-installation Information

.............................. 6

Installing the Gas Fireplace

 ............................................. 7

Clearance to Combustibles

 ............................................. 8

Supporting Floor Systems ............................................... 9

MASON-LITE Weight Determination

 ............................... 10

Mason-Lite™ Component for combustible floors

 ............ 11

Field Assembly Procedures

 ............................................. 11

Fireplace Assembly Procedures

 ...................................... 12

Vent Plate

 ........................................................................ 13

Firestop Radiation Shield ................................................ 14

Mason-Lite™ Firebrick Liners

.......................................... 14

Fireplace Finishes & Combustible Trim Clearances

 ........ 15

Mantle and Mantle Shelf Clearances

............................... 16

Installing Outside Combustion (make-up) Air

 .................. 16

Adding a Gas Pipe

........................................................... 16

Adding Electrical Connection

........................................... 16

MASON-LITE Chimney Systems:

.................................... 16

Installing Chimney System .............................................. 17

Fireplace Door Accessory

................................................ 17

Customer Service & Parts Replacement

 ......................... 17

Appendix I........................................................................ 18

Installing the Spill Switch and Baffl e Assembly

 .............. 19

Installing Spill Switch and Baffl e assembly

 ..................... 19

Owner’s Operation & Precautions

 ................................... 19

Installing the Gas Burner  ................................................ 20

Attaching the Burner and the Grate 

 ................................ 20

Checking and Adjusting the Pilot (if neccessary) 

............ 20

Heat shield placement 

 .................................................... 20

Adjusting Air Mixers 

 ........................................................ 20

Placing the Decorative Lava Rock 

.................................. 20

Placing the Logs 

 ............................................................. 21

Log Placement 

................................................................ 21

Lighting and Operating Instructions 

 ................................ 22

Lighting the Pilot 

 ............................................................. 22

Lighting and Extinguishing the Burner System 

 ............... 22

Maintaining the Pilot 

 ....................................................... 22

Cleaning and Checking 

 .................................................. 22

Safety Pilot System 

 ........................................................ 22

Maintenance and Service 

 ............................................... 23

Troubleshooting  .............................................................. 23

Maintenance 

 ................................................................... 23

Service 

............................................................................ 23

Flame Appearance 

 ......................................................... 23

Troubleshooting  .............................................................. 23

Содержание Mason-Lite MGFPST-43A




























Отзывы: