Instructions
REV 27 NOV 2018
Report No.
08-154
Mason-Lite See-Thru Complete Gas Fireplace
Models:
MGFPST-43(P)A
w/ Remote Valve
installation
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do
not use any phone in your building.
•
Immediately call your gas supplier from
a neighbor’s phone and follow the gas
supplier’s instructions.
•
If you cannot reach your gas supplier,
call the fire department.
Installation and service must be
performed by a qualified installer, service
agency, or the gas supplier.
ê
! WARNING:
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
The logs and burner must be permanently installed in and
are only for use in this fireplace. This fireplace must be
connected to a working flue meeting the requirements of
the ANSI Z21.50 standard.
Solid-fuels shall not be burned in this fireplace.
This appliance must be vented vertically through the
roof. This appliance is not for installation in manufactured
or mobile homes. The installation, including provisions
for combustion, ventilation air, and required minimum
permanent vent opening, must conform with the
National
Fuel Gas Code (ANSI Z223.1/NFPA 54)
and applicable
local building codes.
This gas fireplace is designed to
burn with yellow flames; thus adequate ventilation is
absolutely necessary.
IMPORTANT:
READ THESE INSTRUCTIONS
CAREFULLY BEFORE STARTING
INSTALLATION OF THIS FIREPLACE.
ê
! WARNING:
This gas appliance must not be connected to a chimney
fuel servicing a solid fuel burning appliance.
Do not store gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Equipped with Safety
Pilot System / Remote
Control Valve
This appliance is only for use with the type
of gas indicated on the rating plate. This ap
-
pliance is not convertible for use with other
gasses, unless a certified kit is used.
Low profile or pan
burners are not
allowed for use in
these units without a
metal base
