mFi MASON-LITE MFP- 75, Инструкция по эксплуатации

Страница: 9 / 22

8
Product Overview
Introduction
We extend a warm welcome from all of us at Masonry
Fireplace Industries, LLC. (MFI), proud manufacturers of
Mason-Lite Fireplaces. Thank you for Choosing MFI.
You may have thought long and hard before you chose
the fireplace which would grace your home. Rest assured
that every component of the Fireplace has been tested to
ensure long-term durability.
Product Overview
Mason-Lite Fireplaces are designed as factory-built
blocks to be assembled on-site. These fireplaces may be
installed on either combustible or non-combustible floors.
In order for the fireplace to be installed on a combustible
floor though, it is necessary that the fireplace be supported
on a platform or sub-floor that is non-combustible.
The Four Components of the Mason-Lite Fireplace:
•
Combustible or Non-Combustible Floor
•
Non-Combustible Raised Platform
•
MASON-LITE Firebox and Smoke Dome
•
UL103 class A listed chimney system required.
Important : Follow the chimney pipe
manufacturer’s instructions on the installation of
their specific flue system.
Careful step-by-step instructions for each phase of
the installation procedure will be given for the Mason-Lite
conventional radiant heat fireplaces. Those instructions
generally fall into the following categories:
•
Spacing and clearance as it relates to combustible
materials.
•
Familiarity of installation for all components.
•
The strength of the floor on which it rests.
•
Chimney system measurements.
•
Choice of materials and craftsmanship in fireplace
and hearth finishing.
Note that each of these topics will be covered in detail and
that the installer is expected to understand each phase
completely before going on to subsequent instructions.
Attention : Be advised that all the illustrations in this
manual are for general reference only. Do not scale
drawings. Actual design elements will vary from case to
case. Pay attention to specified minimum clearances to
combustibles.
Testing and listing for these Mason-Lite Fireplaces has
been undertaken by PFS, Inc.
Attention : You may need a residential building permit to
install a Mason-Lite Fireplace. Consult local jurisdictions
before you get started!
If asked, advise the local authorities that the
Mason-Lite Fireplace is designed for installation per the
National Fire Protection Association Standard for
Chimneys, Fireplaces, Vents and Solid Fuel-Burning
Appliances (NFPA211).
When choosing the location of your Mason-Lite
Fireplace, keep in mind you must maintain 2” (two inches)
minimum clearance from left, right and rear of Fireplace to
surrounding structure. Also, when choosing a location,
consider outside air requirements to determine if it will be
on the left or right side of the Fireplace. In the case of an
island installation, outside air accessibility may be obtained
through sub flooring.