mFi MASON-LITE MFP- 75, Инструкция по эксплуатации

Страница: 16 / 22

15
14. Position Middle Domes, which come in one longer
piece and one shorter piece, so that outer faces
are flush to the lower dome as shown.
15. Carefully install Dome Middle Sides as shown in.
16. As you are connecting each MASON-LITE component,
be certain you are following the instructions given previously
for using MASON-LITE mortar. Stop to look at the smoke
dome side, front and rear walls to see that they are aligning
correctly and that the surfaces are smooth and uniform.
Make sure connections are covered with an adequate
amount of mortar. Remember that you have the option of
using shims but they must be removed and any holes filled.
Make any adjustments to the fireplace alignment before
continuing to the next step.
17. Assemble Upper Domes, which also come in one longer
piece and one shorter piece, and Dome Sides
as shown. Check your assembly here. If things are
proceeding as they should be, the finished top surface should
be flat and level.
18. Finally, set the Dome Top into position (2 halves). Be
sure that it is flush in every direction as you place it on the
crest of the smoke dome wall assembly.
19. Now that you have completed the smoke dome
assembly, all the components should stack up for a smooth
transition into the flue components. Setting the smoke dome
completes the MASON-LITE Firebox and Smoke Dome
assembly. You are now ready to begin the installation of the
necessary fire brick lining and the flue components.
WARNING: DO NOT PACK REQUIRED AIR SPACES
WITH INSULATION OR OTHER MATERIALS.