mFi Mason-Lite LMFP-108, Инструкция по эксплуатации

Страница: 32 / 37

32
ELECTRONIC IGNITION
ENCLOSURE
BOX INSTALLATION
1. The EIS box comes with
a 72” pilot assembly
lead, therefor the box
must be mounted
within 5’ of the
fir eplace.
2. A � ach the metal
enclosure to the studs
using standard building
materials. The metal
enclosure must be
mounted in a loca �o n
that can be accessed in
the future for add i� onal
conne c� ons & future servicing.
GAS LINE INSTALLATION
• Installa � on and servicing of gas appliances and igni � on systems
must only be performed by quali fi ed personnel.
• Turn o ff gas and electricity before star � ng installation or
service.
• Make sure gas piping is pressure tested before control is
connected. High pressure can damage the control causing a
hazardous condi � on.
• Make sure piping is clean and free from burrs. Apply a small
amount of good quality pipe thread compound or plumbers
tape suitable for the gas being used. Thread compound should
be used sparingly on male threads only, leaving the fi rst two
threads clean.
• It is recommended that a safety shut o ff valve is installed on
either the gas in or gas out, side of the valve.
• It is recommended to hard pipe in the connec � ons with unions
installed inside the box.
PILOT INSTALLATION
• Un-coil the pilot tubing & the spark ignitor using proper
aluminum tubing bending techniques.
• Insert the pilot hood w/assembly into the fir eplace being
careful not to clog the head of the pilot assembly or damage the spark ignitor.
• Securely screw the pilot assembly to the pilot moun � ng bracket on the back or side of the burner. Screwing the
pilot to the burner completes the electrical circuit.
• With the opposite end of the pilot assembly, plug the orange spark ignitor into the module according to the below
wiring diagram & insert the pilot tubing into the right side of the valve where the compression nut is located.
Once the pilot tubing is inserted into the compression nut, using a wrench, �g hten the nut so that the pilot tubing
can not be pulled out.
WIRING DIAGRAM INSTALLATION
• Electronic Igni � on Systems come full wired according to the manufactures recommenda � ons & the below wiring
diagram.
• It is the job of the electrician to read the wiring diagram according to RobertShaw specifications.
5’
Gas In
Gas Out