MINI-BIKE ASSEMBLY GUIDELINES
- 17 -
26. INSTALL THE FOOT PEGS
❍
Secure the pair of Folding Foot Pegs (Item 7) to the Frame
with four Clamp Halves (Item 23), two 5/16-18 x 1" Bolts,
(Item 27) and two 5/16-18 Locknuts (Item 30).
❍
Beginning with either side, position a Clamp half onto the
outside of the lowest horizontal Frame member just in front of
the engine mounting plate.
❍
Remove the pre-installed Lockwasher and Jamnut from one of
the Foot Pegs. In its “down” position, twist the bolt end of the
Foot Peg into the top hole of the positioned clamp half .
❍
Position another Clamp half on the inside of the frame
member, aligning its top hole with that of the first half and
twist the bolt end of the Foot Peg through the second clamp
hole.
❍
On the threaded end of the Foot Peg , re-install the
Lockwasher and Jamnut you removed previously, but do not
tighten down yet.
❍
Twist a 5/16-18 x 1" Bolt through the bottom holes of the
outside Clamp halves and install a 5/16-18 Locknut, but do
not tighten down yet.
❍
Position the foot peg so that when folded down it is horizontal
with the ground and its foot pad is pointing straight up and
then tighten down the upper Jamnut and lower Locknut until
the clamp and Foot Peg are secure.
❍
Repeat the same procedure with the second Foot Peg on the
opposite side of the Mini-Bike.
☛
PRIOR TO OPERATION. . .
❍
Read/follow the engine manufacturer’s instructions carefully.
❍
Check the engine crankcase for proper engine oil levels and
the fuel line connections before adding fuel and starting the
engine.
❍
Ride safe and have fun!
