Meyra 2.322, Руководство по техническому обслуживанию и ремонту

Страница: 34 / 52

34
Carbon brushes
When the motor is not running flawless and defects in the
incoming lines can be excluded the four carbon brushes
have to be checked one after the other.
☞
Note:
The carbon brushes are supplied in a set, completely
assembled with brackets and are always to be replaced
as a set!
☞
Do not touch the friction surface of the carbon brushes!
Disassembly of the carbon brushes
1. Switch the vehicle off and pull the battery-/mains fuse.
☞
For this observe chapter
Main fuse
on page 26.
2. Remove the front panel.
☞
For this observe chapter Revetment on page 25.
3. Remove the plus cable and the minus cable from the
motor.
4. Pull back the rubber buffer (1) from the motor.
5. Remove the fixing screw (3) from the carbon brushes
(2).
6. Push the carbon brush retainer in the direction of the
screw hole (4).
7. Slightly pull the carbon brush retainer back form the
motor opposite of the screw holder (5).
8. Press the carbon brush retainer in the opposite direc-
tion of the screw hole [6].
9. Slightly pull out the carbon brush retainer [7].
☞
Note:
Two opposite carbon brushes each are connected with
each other through a cable (8) that runs over the motor.
1
2
3
6
4
5
7
8