Meyer SX168720202, Руководство владельца/оператора, Страница: 39 / 112

1-800-325-9103
PB-SXI - 39 - www.meyermfg.com
8.1.5 Automatic Chain Oiler
The automatic chain oiler attachment gives a squirt of clean oil to all roller chains every time that the spreaders rear gate,
hydraulic cylinder is activated. In this way, the spreaders roller chains get oiled in direct proportion to the number of
hydraulic cylinder cycles of the rear gate. This assures adequate lubrication.
New 30 weight oil, which is placed in the reservoir tank mounted on the spreader, is all that is needed to properly
lubricate all roller chains and sprockets. The automatic chain oiler does not use any oil from the tractor’s hydraulic
system. The hydraulic hose connected to the bottom of the oiler pump only serves to power the piston in the pump every
time that the spreader’s rear gate is opened.
Should the oil reservoir tank run dry, pour about a 1/2 cup of
clean 30 weight oil into the tank. Allow time for the oil to run
down into the oiler pump slowly and allow air to escape. After
thirty minutes to one hour has passed, finish filling the reservoir
tank. Make sure that all fittings and brackets are tight when
finished filling the tank.
While running the tractors hydraulics only, open and close the
spreaders rear gate several times. This will cycle the hydraulic
cylinder leading to the oiler pump. Keep cycling until oil can be
seen in all of the oil lines leading to the oiler brushes. (If you
experience problems priming the oiler pump, you may need to
bleed air out of the hydraulic hose where it is connected to the
pump. Crack the fitting until oil comes out, and then re-tighten.)
The hydraulic cylinder that the oiler pump is tied into is double
acting and must reach 300 PSI of pressure to actuate the
pump.
When replacing oiler brushes into brush holders, use regular 1/2”-20 nuts. Tighten nut finger tight initially as some
adjustment may be needed later. For best results, place brush holders over top of roller chains and directly on top of
sprockets. Adjust brush holders so oiler brushes are pushed down into the roller chain approximately 1/2”. Carefully
tighten up the 1/2”-20 nuts on the oiler brushes. DO NOT over tighten as damage to the brush will occur. The plastic
threads of the oiler brush will crack and then break off from the brush body.
Shutoff and lockout power before performing machine service,
adjusting, maintaining, or clearing an obstruction from this machine.
Refer to section 5.3 SHUTOFF & LOCKOUT POWER.
Hydraulic fluid escaping under pressure can have sufficient force to
cause injury. Keep all hoses and connections in good serviceable
condition. Failure to heed may result in serious personal injury or death.
Activating
Hydraulic
Hose
Oiler
Pump
The 5/32” oil line tubing can only be removed from an oiler brush by
pushing in on the red plastic ring and pulling the tubing out while
holding the ring down.