METSYS ML2/3 LINE LASER OPERATTING MANUAL
Down Dot
⇒
④All lines and dots light up
Switch to Pulse Mode:
• Turn on the laser tool, long press of the Operation Button to turn on Pulse Mode, and can be
used with a laser detector.
Note:
The laser beam is dimmer in pulse mode.
Turn OFF the laser tool:
If the laser tool is in self-leveling mode:
Slide the side switch to the Locked Position to turn laser
tool OFF.
If the laser tool is in manual mode:
• Method 1: Slide the side switch to the Unlocked Position, and then slide the switch again to the
Locked Position to turn laser tool OFF.
• Method 2: Short press of the button to switch the laser line in order. After “④All lines and
dots light up”, short press of the button again to turn laser tool OFF.
Note
: The laser level can only be turned off when the side switch is in the Locked Position.
Self-leveling Mode
• is enabled when the laser tool is switched to the unlocked position.
• has laser plumb blink fast when tool is out of self-leveling range (±3.5°).
Note
: When using Self-leveling mode, please place this laser tool on a level surface.
Manual Mode
• Slide the side switch to the Locked Position, then press button and hold for ≥ 2 seconds to turn
on the manual mode.
• The laser beam(s) will blink about every 3-5 seconds to notify the user.
Specifications
Model
ML3 Red
Beams
ML3G Green
Beams
Laser Wavelength
635-660nm
510-520nm
Laser Class
Class 2 (IEC/EN60825-1/2014), ≤1mW
Leveling Accuracy
±3mm/10m
Horizontal/Vertical Accuracy
±3mm/10m
Plumb Dot Accuracy
1.4mm/1m
Leveling/Compensation Range
±3.5°
Working Distance (Line)
20m
25m
