METSYS ML2/3 LINE LASER OPERATTING MANUAL
Operation Modes
Turn ON the laser tool:
•Method 1: Slide the side switch to the Unlocked Position to turn on the laser tool.
•Method 2: When the pendulum in Locked Position, press operation button and hold for ≥ 2
seconds to turn on the laser tool.
•The LED Indicator will light up when the laser tool turn on.
Lines switching:
• Short presses of the operation button repeatedly to switch the composition of different laser
lines.
• Laser line will switches in the following order:
①All lasers light up
⇒
②Horizontal Line
⇒
③Vertical Line
⇒
④Horizontal Line + Vertical Line
⇒
⑤Down Dot + Up Dot
Switch to Pulse Mode:
• Short press of the Pulse button to turn the Pulse Mode on, the LED Indicator will light up.
Note:
The laser beam is dimmer in pulse mode.
Turn OFF the laser tool:
If the laser tool is in self-leveling mode:
Slide the side switch to the Locked Position to turn laser
tool OFF.
If the laser tool is in manual mode:
• Method 1: Slide the side switch to the Unlocked Position, and then slide the pendulum again to
the Locked Position to turn laser tool OFF.
• Method 2: Short press of the operation button to switch the laser line in order. After “⑤Down
Dot + Up Dot”, short press of the operation button again to turn laser tool OFF.
Note
: The laser level can only be turned off when the side switch is in its Locked Position.
Self-leveling Mode
• is enabled when the laser tool is switched to the unlocked position.
• the laser will blink fast when tool is out of self-leveling range (±3.5°).
Note
: When using Self-leveling mode, please place this laser tool on a level surface.
Manual Mode
• Slide the side switch to the Locked Position, then press Laser button and hold for 3 seconds to
turn on the manual mode.
• The laser beam(s) will blink about every 3-5 seconds to notify the user
