METSYS ML2/3 LINE LASER OPERATTING MANUAL
injury may result.
• An exposure to the beam of a Class 2 laser is considered safe for a maximum of 2 seconds.
Eyelid reflexes will normally provide adequate protection.
• The following label/print samples are placed on the product to inform of the laser class for your
convenience and safety.
User Guide, Maintenance and Care
• When not in use please power OFF the tool and place the pendulum lock in its locked position.
• In Manual Mode, self-leveling is OFF. The accuracy of the beam is not ensured to be level.
• The laser tool is sealed and calibrated at the plant to the accuracy specified.
• It’s recommended to carry out an accuracy check before its first use and periodic checks during
future use especially for precise layouts.
• Do not store the laser tool in direct sunlight or expose it to high temperatures.
The housing and some internal parts are made of plastics and may become deformed at high
temperatures.
• Exterior plastic parts may be cleaned with a damp cloth. Although these parts are solvent
resistant, NEVER use solvents. Use a soft, dry cloth to remove moisture from the tool before
storage.
• Store the tool in its case when not in use. If storing for extended time, remove batteries before
storage to prevent possible damage.
• Do not dispose of this product with household waste.
• Always dispose of batteries per local code.
• Please recycle in line with local provisions for the collection and disposal of electrical and
electronic waste under the WEEE Directive.
Battery Safety
• Keep the battery away from children, and pets.
• Please pay attention to the position of the positive and negative pole.
• Please replace new alkaline batteries instead of carbon batteries. The battery capacity should
be more than 1500mA each.
• Do not mix old and new batteries. Replace all of them at the same time with new batteries of
the same brand and type.
• When the device will not be used for a long time, please remove the batteries and store them
in dry condition.
