metso automation kajaaniMCAi, Инструкция по установке, эксплуатации и обслуживанию

Страница: 34 / 75

kajaaniMCA i – Installation, Operating & Service
- 9.7 -
W4610201 V2.5 EN
9.D.4. Naming a recipe
Name the recipes as follows:
1. In the “Recipe” menu press [F7&F8] E
DIT RECIPE
NAME
.
2. Type the desired recipe name in the table that
appears on the screen.
3. Press [F1&F2] S
AVE
.
NOTE: This function only applies to the recipe currently
in use!
Even if another recipe was selected, the name will be
given to the currently used recipe. When a recipe has
been named, both the recipe table (in “Recipe menu”)
and the status line of the main menu will show the recipe
name instead of its number.
9.D.5. Connecting binary inputs
The binary inputs are isolated. The recipe number can
be entered either from the mill system or manually with
a switch. A binary number is converted into a recipe
number with the formula:
Recipe number = 1 x bin1 + 2 x bin2 + 4 x bin3
where bin1, bin2, bin3
= 0 at input voltage 0–2 V
= 1 at input voltage 12–48 V
The accepted recipe numbers are 1–7. If zero is
entered to the binary inputs, the MCAi will automati-
cally activate recipe 1. Table 9.1 illustrates recipe
selection with the binary inputs.
Table 9.1. Status of binary inputs for the selection of recipes.
bin3 bin2 bin1 Recipe in use
0 0 0 or 1 1
0 1 0 2
0 1 1 3
1 0 0 4
1 0 1 5
1 1 0 6
1 1 1 7
Table 9.2. Binary inputs needed when using different num-
bers of recipes.
Number of Inputs Recipes Number
inputs of recipes
1 Bin 2 1, 2 2
2 Bin1, 2 1, 2, 3 3
2 Bin 2, 3 1, 2, 4, 6 4
3 Bin 1, 2, 3 1–7 7
The number (or name) of the currently used recipe is
shown on the Status line in the bottom of the Main
menu, e.g. Recipe 4. If the selected recipe is blank, the
Status line will read Blank recipe.
Table 9.2 shows the binary inputs needed when
using different numbers of recipes.
NOTE: When two inputs are used, the number of avail-
able recipes is either 3 or 4, depending on the connec-
tions! This is because binary numbers 0 and 1 both refer
to recipe 1.
NOTE: Pay attention to the coding of recipe numbers
when connecting two inputs to Bin2 and Bin3!