metrotek Bercut-ETL, Руководство по эксплуатации

Страница: 19 / 25

19
5. Remote management
5.1 Remote control via Telnet potocol
Telnet (Telecommunication Network) is a network protocol used for access to
the remote network device. This network protocol allows the user of the personal
computer to cooperate with the device on the other end of connection. By means
of the commands presented in the table 5.1 and 5.2, it is possible to configure
device and view current settings.
To manage Bercut-ETL over Telnet protocol connect to the device through
the Ethernet interface or directly.
Default IP address of the loopback device is 192.168.1.1.
Username —
admin , default password — admin .
Table 5.1. Remote management commands; show mode
Command
Information shown in the console or action
performed
show version
software versions
show link the state of the interface
show ip address interface IP address
show ip netmask
interface subnet mask
show ip gateway gateway IP address
show gbe speed interface speed
show gbe autonegotiation interface autonegotiation state
show gbe mac
interface MAC address
show oam mode OAM mode: off/passive
show oam discovery state of OAM discovery process
show tftp
state of a TFTP server: on/off
show vlan mode vlan state: on/off
show vlan id vlan identifier
show vlan priority
vlan priority
reboot
reboot device
configure switch to configuration mode
exit finish session
help
list of available commands
Bercut-ETL. Operating manual