Metrologic SP5500 OptimusS Series, Руководство пользователя

Страница: 48 / 61

26
Application Creation
Bar code properties (cont.)
Enable EAN13
ISBN / ISSN Conversion
If these settings are enabled, the scanner will convert the code read into ISBN or
ISSN code if the formats are correct (EAN13 codes start with 978 or 979 for ISBN,
and 977 for ISSN).
Transmit Checksum
If this parameter is enabled, the checksum character will be included in the data
being transmitted.
Enable G.T.I.N. (Global Trade Identification Number)
This setting enables the scanner to scan and decode the GTIN embedded within
the EAN8 and EAN13 bar code types.
Enable EAN13 Addon
Enable EAN13 Addon 2
Setting enables the ability of the scanner to scan and decode the 2 character
supplemental.
Enable EAN13 Addon 5
Setting enables the ability of the scanner to scan and decode the 2 character
supplemental.
MSI
MSI is a variable length, numeric-only bar code type. The bar code type is based on a
four bit binary number scheme. Each character is framed by a start and a stop pattern
and contains a check character that is calculated from the values of each of the encoded
data digits.
Checksum Verification
Setting specifies that the scanner
will perform checksum verification
when decoding bar code. Three
kinds of checksum calculations can
be implemented for MSI code.
Single Modulo 10
Enables the Optimus to scan and
decode bar code that contain the
single Modulo 10 checksum.
Figure 16