MS1633 FocusBT Connection Setup (Continued)
34) In the
Metrologic SoftWedge Utility
window under
Comm Port
select the COMM port
your scanner is connected to. This port was established at the end of the “
Add a New
Connection Wizard
” in the beginning of the FocusBT Connection Setup section.
35) Next to “
Port Selected
” Click the Box. At this point you will notice that the red “
Not
Connected
” will be replaced by a green “
Connected
” Click
OK
to close the window.
MS1633 Focus BT Scanner Installation Guide
25
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
